Sony DSR-450WSL/450WSPL Camcorder User Manual


 
104
Adjustments and Settings from Menus
Chapter 5 Menu Displays and Detailed Settings
Selecting the output signals
(DSR-450WS/450WSP only)
When the CBK-SD01 SDI Output Board is installed, you
can select the type of video signals from the VIDEO OUT
connector on the OUTPUT page. You can select either
VBS or SDI.
Please note that only the picture obtained during recording
is displayed on a CBK-SD01 SDI Output Board. Playback
picture cannot be output.
1
Display the OUTPUT page of the OPERATION
menu.
For details on menu operations, see “Basic menu
operations” on page 93.
2
Press the MENU knob. Then turn the MENU knob to
move b to REAR BNC OUT SEL, and press the
MENU knob again.
b changes to z and z changes to ?.
3
Turn the MENU knob to change the desired setting,
and press the MENU knob.
The settings of SDI and VBS are follows.
z changes to b and ? changes to z. The selection is
set.
Setting the color temperature
manually
You can adjust the value of the white balance manually by
setting the color temperature.
1
Display the WHITE page of the PAINT menu.
For details on menu operations, see “Basic menu
operations” on page 93.
You can set the following items on the WHITE page.
The above table shows the adjustment of the white
balance of channel A. Items followed by <B> are used
to adjust the white balance of channel B.
2
Perform the settings for each item.
Setting value Description
SDI Outputs the SDI signal. When SDI
is selected, connect to the SDI IN
connector of the video monitor.
VBS Outputs the analog composite
video signal. When VBS is
selected, connect to the VIDEO
IN connector of the video monitor.
This setting allows you to save the
power.
Item Description
COLOR TEMP
<A>
Sets the color temperature for the
desired value. Adjust the value
while looking at the real image
because error tends to be bigger
for adjustment of high color
temperature.
COLOR FINE <A> Adjusts the value more precisely
when the color temperature
adjustment through COLOR
TEMP is not satisfactory.
R GAIN <A> Changes only the value of R
GAIN.
B GAIN <A> Changes only the value of B
GAIN.
D5600K <A> Sets the color temperature to
approximately 5600K.