Filter
Top Products
Chapter 4 Viewfinder Screen Indications and Menus 101
Chapter 4 Viewfinder Screen Indications and Menus
Advanced menu page 3
a) For DSR-370P/570WSP: EBU75
Item
AWB MEM
Selects whether or not
to make the FILTER
control settings (1 to 4)
correspond to
separate white
balance adjustment
values stored in
memory.
2 (normal value): No
correspondence with FILTER
control settings. Only two
adjustment values (A and B) are
stored in memory.
2 × 4FL: Correspondence with
FILTER control settings. Each of
the four control settings can be
used to set A and B adjustment
values, for a total of eight settings.
TONE
Selects whether or not
to output a 1-kHz
audio signal with the
color bars when the
OUTPUT/DL/DCC+
has been set to
BARS.
ON (normal value): Outputs
audio signal.
OFF: Does not output audio
signal.
BARS
Selects normal width
or narrower width for
color bars.
REMOTE1
Sets a function for
switch 1 of the RM-
LG1 connected to the
REMOTE connector 1.
REC (normal value): Specifies
recording start/stop.
MARK: Specifies a Mark IN/OUT
point.
CUE: Specifies a Cue point.
NG: Specifies NG/OK.
REMOTE2
Sets a function for
switch 2 of the RM-
LG1 connected to the
REMOTE connector 1.
9600, 38400 (normal value)
REC:
Specifies recording start/stop.
MARK (normal value): Specifies
a Mark IN/OUT point.
CUE: Specifies a Cue point.
NG: Specifies NG/OK.
Settings
BAUD RATE
Sets a baud rate for a
computer connected
to the REMOTE
connector 2 (to be
supported in the future
version).
SMPTE (normal value for DSR-
370/570WS): Normal width
EBU75 (normal value for DSR-
370P/570WSP): EBU 75%
EBU100 (for DSR-370P/
570WSP): EBU 100%
SPLIT (for DSR-370P/570WSP):
Not for normal operation
SNG: Narrower than normal (used
for satellite communications, etc.)
iLINK CTL
Selects whether to
control from the
camera the start and
stop of recording by
the external VCR
connected to the DV
OUT connector.
REC/P (normal value): When an
external VCR is recording or
recording paused, control from the
camera according to the setting of
the VTR TRIGGER switch.
ALL: When an external VCR is
recording, recording paused, or
stopped, control from the camera
according to the setting of the VTR
TRIGGER switch.
For the DSR-1500/1500P/1600/
1600P/1800/1800P/2000/2000P,
which cannot be set to recording
paused, set this item to ALL.
OFF: Do not control from the
camera.