Filter
Top Products
12
Basic Functions
User Memory Area
A user area of 16 bytes allows you to write data, such
as an ID for each customer, data for each system, and
so on, freely.
Note
Rewriting of memory is not unlimited. Be careful to avoid using
the memory area for such as unnecessary tasks as rewriting the
contents of the memory for every operation.
Privacy Zone Settings
For details, see page 13.
Motion detection
For details, see page 17.
Title Display
•You can set a title composed of up to 11 lines. One
line can contain up to 20 characters.
•You can set display on/off, the horizontal position of
the first character, blinking state and color for each
line.
• The camera gives priority to lines of a title when the
camera status is displayed on the relevant line. On the
lines where a title is not set, the camera status is
displayed.
Line Number 00 to 0A
H-position 00 to 17
Blink
00: Does not blink
01: Blinks
00 White
01 Yellow
02 Violet
Color 03 Red
04 Cyan
05 Green
06 Blue
00 01 02 03 04 05 06 07
AB CDEFGH
08 09 0a 0b 0c 0d 0e 0f
IJKLMNOP
10 11 12 13 14 15 16 17
QR STUVWX
18 19 1a 1b 1c 1d 1e 1f
YZ& ? ! 1 2
20 21 22 23 24 25 26 27
34567890
28 29 2a 2b 2c 2d 2e 2f
ÀÈ ÌÒÙÁÉ Í
30 31 32 33 34 35 36 37
ÓÚÂÊÔÆŒÃ
38 39 3a 3b 3c 3d 3e 3f
ÕÑ ÇßÄ Ï ÖÜ
40 41 42 43 44 45 46 47
Å$
F
¥DM£ ¿ ¡
48 49 4a 4b 4c 4d 4e 4f
ø“ :‘ . , / -
Synchronization methods
Internal and external synchronization are available;
VISCA Commands allow you to switch between them.
• Internal synchronization
An internal vibrator inside the camera generates a
synchronizing signal as a basic oscillator.
NTSC=28.636363MHz
PAL=17.7344MHz
• External synchronization (V-Lock Synchronization
1)
)
When a TTL level V-Lock pulse is input, the camera
synchronizes to the input signal (V-lock
synchronization). The frequency of the input signal
synchronizes to within ±1Hz of the external
synchronization.
Also, 360 degree phase adjustment is possible due to
the phase adjustment of the V-lock signal.
Because V-lock synchronization is a simple synchronization
method, color signals like a VBS “Genlock” signal cannot be
synchronized.
1)In V-lock synchronization, the camera makes a V-lock pulse
(VL-PULSE) which synchronizes to the commercial power
supply and uses it as the external synchronization input signal
of the camera, using the fact that the V cycle (59.97 Hz vertical
synchronization signal) and the frequency of the commercial
power supply (60 Hz). The synchronous signal of the camera
will automatically sychronizes to the VL-PULSE in the
camera.