Filter
Top Products
62
US
The battery pack temperature is high. Change
the battery pack or place it in a cool place.
Because the temperature of your camcorder
has reached a level where HDMI output
has stopped, no image is displayed on the
connected monitor, etc. Leave the camcorder
until the temperature decreases. However, you
can continue recording on the camcorder.
No memory card is inserted (p. 24).
When the indicator flashes, there are not
enough free spaces for recording images.
D
e
lete unnecessary images (p. 45), or format
the memory card after storing the images on
o
t
her media (p. 58).
The image data base file may be damaged.
Check the data base file by selecting
[Setup] [
Media Settings] [Repair
Img. DB F.] the recording medium.
The memory card is damaged.
Format the memory card with your camcorder
(p.
58).
Incompatible memory card is inserted (p. 24).
The memory card is write-protected.
Access to the memory card was restricted on
another device.
There is something wrong with the flash.
The amount of lights is not sufficient, so
camera-shake easily occurs. Use the flash.
The camcorder is unsteady, so camera-shake
easily occurs. Hold the camcorder steady with
both hands and record the image. However,
note that the camera-shake warning indicator
does not disappear.
The recording medium is full.
Photos cannot be recorded during processing.
Wait for a while, then record.
When [
REC Mode] is set to [Highest
Quality
] or [60p Quality ], you cannot
capture photos while recording movies.
Furthermore, if [
Frame Rate] is set to
[24p], you cannot record photos while the
camcorder is in movie recording standby
mode.
The distance between your camcorder and the
subject is too short. Widen the distance (p. 30)
or set the zoom to W. Or, select [Manual] in
[3D Depth Adjustment] and adjust the depth
(p. 56).