Sony MVC-FD100 Digital Camera User Manual


 
masterpage:Right
filename[G:\_Upload\3073074111\307307411MVCFD100UC\02GB-
MVCFD100UC\09add.fm]
91
model name1[MVC-FD100/200]
[3-073-074-11(1)]
Additional information
Your computer does not
recognize your camera.
The battery level is low.
t
Use the AC power adaptor (page 13).
The camera is turned off.
t
Turn on the camera.
The USB cable is not connected firmly.
t
Disconnect the USB cable, and connect it again
firmly. Make sure that USB MODEis
displayedontheLCDscreen(page30).
The USB connectors on your computer are
connected to other equipment besides the keyboard,
the mouse, and your camera.
t
Disconnect the USB cables except for the ones
connected to the keyboard, the mouse, and your
camera.
The position of the MS/FD selector is not set to the
proper position for the media being used.
t
Set the MS/FD selector to the proper position.
The USB driver is not installed.
t
Install the USB driver (page 29).
• For Windows 98, Windows 98SE, Windows
2000andWindowsMeusers
Since the camera is connected to a computer using
the USB cable before installing the USB driver, the
drive is not recognized properly by the computer.
t
Delete the drive which is not recognized
properly, then install the USB driver. For details,
see the procedure on page 33.
Battery packs
Symptom Cause and/or Solution
The battery pack cannot
be charged.
The power of the camera is turned on.
t
Turn off the power of the camera (page 10).
The battery life is short. You are recording/playing back images under
extremely cold temperatures.
The battery pack is not charged enough.
t
Charge the battery pack fully.
The battery pack is dead.
t
Replace the battery pack with a new one.
Symptom Cause and/or Solution
01cov.book Page 91 Thursday, November 29, 2001 1:20 PM