Filter
Top Products
GB
23
Preparing the camera
Attaching the flash
When you want to use a flash during shooting, attach the flash device
(supplied).
The flash is enabled when it is raised, and disabled when lowered.
Set the power switch of the camera to OFF before you attach or remove the
flash.
• The power for the flash is provided from the camera. When the camera is charging
the flash, blinks on the LCD monitor. You cannot press the shutter button
when this icon is blinking.
• Plug the flash fully into the accessory terminal of the camera, and fasten the screw
securely. Make sure that the flash is attached to the camera securely.
1
Attach the flash to the Smart
Accessory Terminal 2 of the
camera.
2
Fasten the screw to secure the flash.
3
To fire the flash, raise the
flash first.
• The default setting is [Autoflash].
To change the setting, see page 48.
• Lower the flash when you do not
intend to use it.
Notes