Filter
Top Products
-8-
3 - 2. Connecting the Power
Connect the appropriate cable to the power cable of the camera.
Referring to the specified label of the camera.
(Be sure to match the correct polarity in case of 12V DC)
Insert the cable into the shrinkable
tube A which shall be around 10mm
and tube B which shall be around 3mm.
After heating the three shrinkable tube B, as shown on the above, put the
shrinkable tube A as the drawing above. The tube should cover the edge of the
connection parts at least over 5mm and shrink it finally with heat. A
pply a silicon
sealant to each ends of the shrinkable tube
and shrink it finally with heat.
Heat the shrinkable tube B after connecting each wire. Be sure to match the correct
polarity in case of 12V DC.
Shrinkable Tube A
Shrinkable Tube B
Power Cable
Power Cable
RED(12VDC+) OR 24VAC(~)
GREEN(COMMON GND)
BLACK(12VDC-)OR 24VAC(~)
SHRINKABLE TUBE
SILICON SEALANT
Shrinkable Tube B
Shrinkable Tube A
Shrinkable Tube B
Shrinkable Tube A
HEATING
INSTALLATION
5mm over