Sony SLT-A55V Camcorder User Manual


 
27
Preparing the camera
To remove the lens
Note on changing the lens
When changing the lens, if dust or debris gets inside the camera and lands
on the surface of the image sensor (the part that acts as the film), it may
appear on the image, depending on the shooting environment.
The camera is equipped with an anti-dust function to prevent dust from
landing on the image sensor. However, quickly change the lens away from
dusty locations when attaching/removing a lens.
If dust or debris lands on the image sensor
Clean the image sensor using [Cleaning Mode] in the Setup menu
(page 36).
1 Press the lens release button all
the way in and turn the lens
counterclockwise until it stops.
Lens release button
2 Replace the packaging lid on the
lens and attach the body cap to
the camera.
Before you attach them, remove dust
from them.
A rear lens cap is not supplied with the DT
18-55mm F3.5-5.6 SAM Lens Kit. When
you store the lens without attaching it to
the camera, purchase the Rear Lens Cap
ALC-R55.