Filter
Top Products
Operating the Camera
Configuration of Main Viewer
19
By pressing , the focus is set to the
optimum position.
Note
To control the focus manually, set “Focus mode” of the
camera setting menu to Manual. (page 36)
Trigger
(Displayed only when the camera Viewer mode
(page 44) is set to Full and one or more triggers are
enabled on the Trigger Setting menu (page 57).)
Select the function you want to use from the list box and
click the icon. Then you can send the monitor image of
the camera to an FTP server (page 25), send it attached
to a mail (page 25), record the image on the built-in
memory (page 25) and switch the Alarm out to On/Off
(page 26).
Transmission (Switching the TCP/
UDP transmission mode)
(Displayed only when the camera Video mode (page 34)
is set to MPEG4 and you are using the ActiveX viewer.)
Each click switches the transmission mode of the video/
audio data among TCP mode, UDP (Unicast) mode and
UDP (Multicast) mode. (page 27)
The last selected mode is saved in the computer, and it
will be selected at the next starting.
(Volume)
(Displayed when the Microphone (page 36) is set to
On.)
Drag the bar of icon to adjust the volume.
When you click icon, the icon changes to and
the audio output stops. To output the audio, click
again.
Note
If the volume icon is not displayed in the case you are
using Java applet viewer, Audio codec may not be set
G.711(64kbps) (page 36) or Java may not be installed
correctly.
To check if Java is installed correctly, refer to “Java
applet viewer” of “About Viewers” on page 16.
Monitor Image
The image shot by the camera is shown here. Date and
time is displayed at the top of the window.