Filter
Top Products
4-2 Operator's Manual LDK 200 Triax Location of Controls and Functions
Call
Mic
VF
Front Rear 48V
Ext
Scrip
Light
Breaker
Power on
DC in
CVBS (option)
Eng Progr Prod
Eng
Off
Prod
Ext
Mix
Front
Rear
Loc
TP
Mic 2
48VOn
12V 1,5A DC Out
Ext 2
Ext 1
Clear
Clear
A
1
Star 4P
ND1/4
B2
Star 6P
ND 1/16
C
3
Soft focus
ND 1/64
D
4
Power Supply
1
1 Power switch
The power switch has two positions:
On : Power to camera is switched on.
Off : Power to camera is switched off.
When you switch off the power, the access rights that
were obtained by the use of the PIN code are
disabled and the camera starts at the assigned
user level when switched on again.
2
2 Power on indicator
The power on indicator lights when power is supplied
to the camera and the camera power switch is
on.
3
3 DC and Tally output socket
This socket supplies +12Vdc (±0.25V) when the
camera is in the Triax mode (maximum current
1.5A). The socket also provides acces to an
internal tally switch. When the camera is on-air
the contact of the internal relay is closed.
4
4 Circuit breaker button (BREAKER)
If excessive current flows in the camera the circuit
breaker trips and shuts off power to all the
units. If this happens check the units for faults
and if necessary take corrective action before
pressing the circuit breaker button to reset the
power.
5
5 DC input socket
This socket accepts a DC supply voltage of 12V
Nominal (11V to 17V) for powering the camera
in stand-alone mode for service purposes.
Maximum power consumption 23W.
CAUTION
The input voltage must not exceed 17 Vdc.
6
6 Triax cable socket
The power supply for the camera is normally supplied
from the Base Station via the the triax cable.
The triax cable is connected to this socket.
The triax cable also carries all the video, audio/
intercom and control signals between the
camera and the Base Station.
1
2
3
4
5
6