Filter
Top Products
Rev 1.0
[Output signal specification]
(1) WEN DC IN connector output
Signal level 4 V (p-p)
Polarity Positive polarity
Pulse width Approximately 53.3 s
Dimensions
(1) Lens mount C-mount
*Depending on the lens you use, the performance of the camera may not
be brought out fully due to the deterioration in resolution and brightness
in the peripheral area, occurrence of a ghost, aberration and others.
When you check the combination between the lens and camera, be sure
to use the lens you actually use.
(2) Flange back 17.526 mm
(3) Dimensions 54 mm (W) x 43 mm (H) x 59 mm (D)
(4) Mass Approximately 150 g
(5) Camera body grounding: insulation status
Conductive between circuit GND and camera body
Operating ambient conditions
(1) Performance assurance Temperature : 0 to 40°C
Humidity : 10 to 90% (no condensation)
Typical spectral response
The lens characteristics and light source characteristics is not reflected in table.
400 450 500 550 600 650 700
0.0
0.2
0.4
0.6
0.8
1.0
Wave Length[nm]
Relative Response
B
G
R
Applicable safety standards
(1) EMC Electro-Magnetic Compatibility
EMI Electro-Magnetic Interference :EN61000-6-3 / 2001
EMS Electro-Magnetic Susceptibility :EN61000-6-2 / 2001
(2) FCC :FCC Part 15 Subpart B class A
D4134176A