Filter
Top Products
D4153659A
13
［
［［
［Machine externals specification]］
］］
］
(1) Dimensions 44mm(W) x 29mm(H) x 70mm(D) (Not including protrusion)
(2) Mass Approximately 120g
(3) Lens mount C-mount
Notes on combination of C-mount lens:
- Depending on the lens you use, the performance of the camera may not be brought out fully due
to the deterioration in resolution and brightness in the peripheral area, occurrence of a ghost,
aberration and others. When you check the combination between the lens and camera, be sure to
use the lens you actually use. As for the C-mount lens used combining this camera, the projection
distance from bottom of the screw should use 9.4mm or less.
(4) Flange back it is not possible to adjust it.
(5) Camera body grounding: insulation status
Conductive between circuit GND and camera body
［
［［
［Operating Ambient conditions］
］］
］
(1) Ambient conditions
- Performance assurance
Temperature 0 to 40
°
C
Humidity 10 to 90% (no condensation)
- Operating assurance
Temperature -5 to 45
°
C
Humidity 90% or less (no condensation)
- Storage assurance
Temperature -20 to 60
°
C
Humidity 90% or less (no condensation)
(2) EMC conditions
- EMI (Electro-Magnetic interference) EN61000-6-4 conformity
FCC part15 Subpart B class A conformity
- EMS (Electro-Magnetic susceptibility) EN61000-6-2 conformity
Notes on Conformity of the EMC:
- About the conformity of the EMC standard of this machine, it has guaranteed in the conditions
combined with the option part of 4th clause.
When used combining parts other than specification of our company, I ask you to have final EMC
conformity checked of a visitor with a machine and the whole equipment.
9.4mm or less
C-mount lens
Bottom of
the screw