Filter
Top Products
7
4. CONNECTION
4. 1 Standard Connection
DC IN 12V
Connector used:
HR10A-7R-4PB
(HIROSE electronics
Co. Ltd) or equivalent.
DIGITAL Function I/O
1 +12V
13
2 +12V
2
3 GND
3
4 GND
4
5
6
7
8
9
10
11
12
1
GND
X0-
X1-
X2-
Xclk-
X3-
SerTC+
SerTFC-
CC1-
CC2+
CC3-
CC4+
+12V
14
15
16
17
18
19
20
21
22
23
24
25
26
–
O
O
O
O
O
I
O
I
I
I
I
–
GND
X0+
X1+
X2+
Xclk+
X3+
SerTC-
SerTFC
+
CC1+
CC2-
CC3+
CC4-
Serial communication control (RXD)
Serial communication control (TXD)
Trigger pulse input
Partial scanning control
External HD input
External VD input
+12V
1
113
26 14
2
4
3
Connector used:
12226-51000-00
(3M) or equivalent.
4. 2 Cautions on Connection
• Only use optional camera head model # IK-TF7H with this camera controller.
The use of another head may cause damage to the control unit and camera head.
• When connecting the camera cables, be sure to turn off the camera control unit and any other equipment
connected to it.
•For DC power supply connecting to DC IN 12V terminal, use UL listed and/or CSA approved ungrounded
type AC adaptor with the specifications described below.
Power supply voltage : 12V DC±10%
Current rating : More than 830mA
Ripple voltage : Less than 50mV(p–p)
•To connect DC IN 12V terminal, use the following connector listed below.
Connector : HR10A–7P–4S by HIROSE electronics Co., Ltd
Pins 1, 2 : 12V , Pins 3, 4 : GND
• If the securing screw on the connector of the camera cable loosens, noise may appear on the screen.
Be sure to tighten the connector completely.
•Use the standard cable for Camera Link.
• Input DC power (12V) either DC IN 12V terminal or DIGITAL terminal. If DC power is supplied input
from both terminals, it may cause trouble.
• More than 830mA is necessary for proper functioning of the unit. Use power line with sufficient quan-
tities of current rating. The unit dose not support PoCL standard.
4. 3 Connector Pin Assignments
DC IN 12V
Camera cable
for IK-TF7U
IK-TF7U
Camera control unit
Cable
(option)
(option)
IK-TF7H
(option)
Lans
(option)
Frame grabber board,
image process
equipment etc.
Monitor
DC power
supply (option)
When connection the frame grabber
board, image process equipment, etc
with power supply function, refer to the
item “4.2 Caution on Connection”.