Filter
Top Products
14
Status LED
The LED indicates the status of the Network Camera.
Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Occasionally
resetting the system can return the camera to normal operation. If the system problems remain
after resetting, restore the factory settings and install again.
Reset:Hold for about 3 seconds and release the recessed reset button. Wait for the Network
Camera to reboot.
Restore:Press and hold the recessed reset button until the status LED rapidly blinks. It takes
about 10 seconds. Note that all settings will be restored to factory default. Upon successful
restore, the status LED will blink during normal operation.
Restoring the factory defaults will erase any previous settings.
Item LED status Description
1
Red LED steady ON
Red LED OFF
Power on and system booting
Power off
2
Steady Red + Blink Green every 1 sec.
Red LED Steady ON + Green LED OFF
Network works (heartbeat)
Network fail
3 Blink Red every 0.15 sec. + Blink Green every 1 sec. Upgrading F/W
4 Blink Red every 0.15 sec. + Blink Green every 0.15 sec. Restoring default