Filter
Top Products
Warning Before Installation
1
Physical Description
2
Package Contents
QIGResource CD
t
MODEL NO. TL-SC4171G
Camera Mounting Bracket Power Adapter
Ethernet Cable
Hardware Connection
4
Router
Internet
WAN LAN
1 2 3
Camera Mounting
3
Antenna Connector
Audio Out
Reset Button
General I/O Terminal Block
Power Connector
Audio In
Network Connector
Power LED
Ethernet LED
Built-in Microphone
Ceiling Mount Wall Mount
1
2
1
2
Fix the camera to the bracket
with two type A screws .
Fix the bracket and camera
to the ceiling using two
type B screws and two
hollow ceiling anchors.
Fix the bracket to the wall
using two type B screws and
two hollow wall anchors.
Fix the camera to the bracket
with two type A screws .
12V DC
Audio in
Audio out
Ethernet
I/O
reset
12V DC
Audio in
Audio out
Ethernet
I/O
reset
Reset Button
Bracket
Type A screws Type B screws
Hollow anchors
NOTE: In the bracket, there are several mounting holes arranged in a circle. The direction of the camera’s
installation can be anywhere within a 360 degree scope, adjusted as required.
It is strongly recommended that you connect the Ethernet cable and power adapter cord to the camera rst
before mounting.
Power LED
Ethernet LED
• Step 1: Re-power on the camera and wait for at least 45s
until it restarts up normally.
• Step 2: Press the button for more than 10s, then it will be
restored to factory defaults after automatic rebooting.
7106503435
Power Cable
Quick Installation Guide
Wireless Pan/Tilt Surveillance Camera
MODEL NO. TL-SC4171G
System Requirement
ChromeFirefoxSafari
(*Windows and Internet Explore Browser are recommended.)
The following operating systems are supported:
Windows 2000
Windows Vista
Internet Explorer 6 or higher
Windows 2003
Windows 7
Windows XP
Mac
The following browsers are supported:
Do not keep the Camera exposed
to direct sunlight.
Do not place the Camera in high
humidity environments such as
in a kitchen.
Do not place the Camera where
there are high temperatures
such as near an oven.
Do not place the Camera near
devices that emit radio waves,
such as mobile phones.
Description
Item
•
The electrical power is on.
Solid:
•
There is no electrical power.
Off:
•
The Ethernet port is linked, but there is no activity.
Solid:
•
There is no network connection.
Off:
•
There is trac between the Ethernet port and
Blinking:
the network.
Connect the Camera to the LAN network (Router or Switch)
via Ethernet cable.
Connect the power adapter cord to the DC In jack.
Plug the power adapter into the power outlet.
Make sure that your router’s DHCP feature is enabled.
If not, please refer to your router’s instruction to
enable it.
Before proceeding, conrm that your PC is connected
to your router and can access the Internet.
(*The pictures are for reference only.)
Ethernet Cable
Quick Installation Guide
Wireless Pan/Tilt Surveillance Camera
*For wireless connection, please refer to User Guide on the Resource CD.