Filter
Top Products
4
Section 2
Getting Up and Running
Loading the Battery
Before using the camera, user must load NP60
rechargeable Li-ion battery.
1. Follow the arrow direction and slide to eject
the battery / SD cover.
2. Face the battery up with letter side upward.
Follow the battery injection direction
according to the correct polarity marks.
( + or -) and plug the battery into camera
3. Closed the battery/SD Card Cover firmly.
Note: NP60 is the widely-used rechargeable Li-ion battery developed by Nokia for mobile
phone.
Charging Battery
Please fully charge Li-ion Battery via power adaptor for at least ten hours before using camera.
(1) Plug power adaptor cable into USB port.
(2) When charging battery, the self-timer LED light keeps blinking. LED light will keep on after
battery charge complete.
(3) It takes three hours to fully recharge the battery each time.
Inserting and Removing an SD Card（Optional）
The camera comes with 16 MB pre-build memory which allows you to store pictures, movies,
recorded voice and music. You can expand the memory capacity by using an optional SD or
MMC memory card up to 512MB. To insert a memory card, refer to the figure above and:
1. Open the battery/SD card cover.
2. Insert the memory card until it locks into position.
To remove an installed SD card, press the card inwards to release it. When the card pops
out, gently remove it from its slot.
SD Card
NP60 Battery