Filter
Top Products
3
Installation Instructions
PRODUCT SAFETY
Installation and servicing is only to be carried out by suitably qualified and
experienced personnel.
Mains cameras contain hazardous voltages.
Do not remove covers as there is a risk of injury or death by electric shock.
Cameras connected to mains supplies must be earthed.
Only power low voltage cameras from a class 2 isolated power supply.
This camera range is designed for use in general purpose CCTV applications and has no other
purpose. Only operate your camera between the temperatures of -10
O
C and +50
O
C. Do not
operate your camera outside its specified power supply range. Cameras must only be used in
clean, dry, dust-free environments unless housed in suitable protective housings to IP65 or
better.
ELECTROMAGNETIC COMPATIBILITY (EMC)
This is a class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
This product is intended solely for use in general CCTV applications.
The product must be installed and maintained in accordance with good installation practice to
enable the product to function as intended and to prevent problems. Refer to Norbain SD Limited
for installation guidance.
MANUFACTURERS DECLARATION OF CONFORMANCE
The manufacturer declares that the equipment supplied with this manual is compliant with the
essential protection requirements of the EMC directive 89/336 and the Low Voltage Directive
LVD 73/23 EEC. Conforming to the requirements of standards EN 55022 for emissions, IEC801
parts 2, 3 and 4 for immunity and EN 60950 for Electrical Equipment safety.