Filter
Top Products
VIVOTEK
6 - User's Manual
Hardware Installation
IMPORTANT:
The diameters of the cable holes on the rubber seal
are shown on the right. Please properly install the
waterproof cable gland and cables through it to obtain
IP66 waterproof functionality.
All units are in millimeters. The cable range for the
Ethernet cable is 6.4 to 4.3mm, 1.6mm for DI lines.
3
1
2
4
Silica gel
M
icro
SD
If you prefer installing a MicroSD card as onboard storage:
1. Loosen the waterproof connector, and then remove the rubber seal, and the waterproof
connector.
2. Loosen and open the rear cover.
3. Install a MicroSD/SDHC card.
4. Tear down the aluminum foil vacuum bag and take out the desiccant bag. Attach the
supplied desiccant bag to the inner side of the Network Camera. (Please replace the
desiccant bag with a new one every time you open the rear cover.)
5. Connect an Ethernet cable and DI lines to the camera, and pass them through the
rubber seal.
5