Filter
Top Products
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
50 - User's Manual
■ Keep current value
Follow the steps below to manually set the white balance to compensate for the ambient lighting
conditions�
1� Set the White balance to Auto and click Save�
2. Place a sheet of white paper in front of the lens, then allow the Network Camera to adjust the color
temperature automatically�
3. Select Keep Current Value to conrm the setting while the white balance is being measured.
4� Click Save to enable the new setting�
Image Adjustment
■ Brightness: Adjust the image brightness level, which ranges from -5 to +5. The default value is set to 0.
■ Saturation: Adjust the image saturation level, which ranges from -5 to +5. The default value is set to 0.
■ Contrast: Adjust the image contrast level, which ranges from -5 to +5. The default value is set to 0.
■ Sharpness:
Adjust the image sharpness level, which ranges from -3 to +3. The default value is set to 0.
Enable Edge Enhancement
Edge enhancement is an image processing lter that enhances the edge contrast of an image or video to
improve its sharpness� Enter a value from 1 to 128 to set the degree of enhancement desired�
Enable Noise Reduction
Noise reduction is the process of removing noise from a signal� Select the type of noise to remove and
enter a value from 1 to 63 to set the degree of enhancement required�
You can click Preview to fine-tune the image, or click Restore to recall the original settings without
incorporating the changes. When completed with the settings on this page, click Save to enable the
setting and click Close to exit the page�