Filter
Top Products
VIVOTEK
50 - User's Manual
■ Iris mode (available for IP8152 using a DC-iris lens):
Select Indoor or Outdoor iris mode to
adapt to the installation� The preset iris aperture setting will apply�
You can click Restore to recall the original settings without incorporating the changes� When
completed with the settings on this page, click Save to enable the settings�
If you want to congure another sensor setting for the schedule mode, please click Prole to open
the Prole of exposure settings page as shown below.
Activated period:
Select the period of time this prole setting will apply to. Please manually enter
a range of time in a day, fune the Measurement window and Exposure control settings, and then
cliack Save for the conguration to take effect.
Please follow the steps below to setup a prole:
1� Select Enable and apply this prole to�
2� Select Day mode, night mode, or Schedule time
by entering a range of time for this profile to
apply to�
3� Select the Measurement window setting�
4� Configure Exposure control settings in the
folowing columns� Please refer to previous
dicussions for detailed information�
5� Click Save to enable the setting and click Close
to exit the page�