Filter
Top Products
- 35 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
Application setup
Weekly Schedule
“Sun” ~ “Sat” Select the days of the week to perform the following operations.
“Snapshots begin at” Set the time to start operations. “Snapshots stop at” Set the
time to stop operations.
Setting identical begin time and stop time means 24-hour operation.
Event operation
“Delay second(s) before detecting next event” Set the time delay before
restarting to check on the triggering condition when the current condition is triggered.
“Take snapshots at second(s) after event” After the camera has taken a snapshot
when a condition is triggered, another snapshot will be taken after this configured
interval, in seconds.
“Trigger condition” There are four conditions relative to the digital input and the
three windows for motion detection. More than one condition can be selected at once.
Select the appropriate digital input condition that suits the characteristics of the
external device. “high”, “low” selects level-triggering via external voltage input.
“rising”, “falling” is for edge-triggering. There are three windows for motion detection
each can be assigned a name. If motion detection has not been set up, “undefined”
will be shown instead of the window title. If this happens, clicking on “Motion
detection” and a note will show to direct the User to the configuration page for motion
detection.
“Trigger action” There are four options for two types of action. More than one
condition can be selected at once. While choosing to trigger an output alarm, the digital
output will short both pins and complete the external device’s circuit. The normal
state is open. Either email or FTP can be used to command uploading snapshots. The
snapshot names will be “vpre.jpg”, “vtrg.jpg”, and “vpos.jpg”, respectively. They