Filter
Top Products
- 31 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
“Channel” While in infrastructure mode, the channel is selected automatically to
match the channel setting for the selected Access Point. In Ad-Hoc mode, the channel
must be manually set to the same channel for each wireless adapter. The default
channel setting depends on the installed region.
“TX rate” This field is for selecting the maximum transmission rate on the network.
The default setting is “auto”, that is the Network Camera will try to connect to the other
wireless device with highest transmitting rate.
“Security” Select the data encrypt method
▶ “None” – No data encryption.
▶ “WEP” – allows communication only with other devices with identical WEP settings.
▶ “WPA-PSK” – Use WPA pre-shared key.
“Auth Mode” Choosing one of the following modes, (Open is the default setting).
▶ “Open” – communicates the key across the network.
▶ “Shared” – allows communication only with other devices with identical WEP
settings.
“Key length” The administrator can select the key length among 64 or 128 bits.
64bits is the default setting.
“Key format” Hexadecimal or ASCII. “HEX” is the default setting.
▶ “HEX” digits consist of the numbers 0~9 and the letters A-F.
▶ “ASCII” is a code for representing English letters as numbers from 0-127 except “,
<, > and space characters that are reserved.
“Network Key” Entering a key in either hexadecimal or ASCII format. When selecting
different key length, acceptable input length is listed as following:
64 bits key length: 10 Hex digits or 5 characters.