Filter
Top Products
Page 2
Step 1: Hardware Installation
You need to set up your camera using a network cable (wired) first before you attempt to use it wirelessly. It is
recommended that you set the camera up indoors first, before routing the cables through an external wall to mount it
outdoors.
1. Install the Wi-Fi antenna.
2. Plug the power adaptor into the camera and into an AC outlet.
3. Plug one end of the network cable into the camera, and the other end into your router/switch.
Step 2: Software Installation
Install the following software:
1. IP Camera Tool: Open the CD, click “IPCamSetup.exe”—“Next”—“Next”—“Close”.
2. ActiveX: Click “Appinstall.exe”—“Next”—“Install”—“Finish”.
After this is done, the icon “IP Camera Tool”
will be displayed on your desktop.