Filter
Top Products
Xerox WorkCentre
®
M123/M128/133
Xerox WorkCentre
®
Pro 123/128/133
Copyright © 2005, 2004 Xerox Corporation. All rights reserved.
1
This guide includes instructions for:
■ Quick Network Setup (DHCP) on page 1
■ Quick Network Setup (Static IP) on page 3
Quick Network Setup (DHCP)
The System Administrator Guide contains detailed information about network setups. This document is
intended for setting up the network using TCP/IP. If using Novel IPX, see the System Administrator Guide
for setup procedures.
Prerequisites for Quick Network Setup Using TCP/IP
1. Confirm that an existing operational network utilizing TCP/IP is available.
2. Confirm that the Ethernet cable is plugged into the multifunction device and into an operational Ethernet
port on the network.
Note
The Ethernet cable is an RJ45 type and is not supplied by Xerox.
Configuring an IP Address via DHCP
On startup, the multifunction device defaults to DHCP to obtain its network configurations. A DHCP server
delivers an IP address, as well as other configuration settings to the device. If you use a DHCP server to
allocate an IP address to the device, then proceed as follows:
Procedure for Quick Network Setup Using TCP/IP
1. Power on the device.
2. Wait a minute or so while the device negotiates an IP address.
3. Print the System Settings List.
a. Select the Machine Status button on the device.
b. Select Print Report List.
c. Select Print Mode Settings.
d. Select Setting List - Common Items.
e. Press the Start button.
Quick Network Setup Guide