Getting to Know Your TrailBlazer
14
Universal Transmitter
(if equipped)
This programmable transmitter can store
three frequencies for items such as a
garage door opener, entry door lock or
security system.
With the ignition off, program the
transmitter as follows
• Hold down the desired button on the
unit until the red indicator light flashes
slowly (about 20 seconds); continue
holding down the button.
• Hold the end of your hand-held trans-
mitter up to three inches away from
the surface of the universal transmit-
ter and hold down the button.
• Up to 90 seconds may pass as the
universal transmitter is being pro-
grammed; programming is complete
when the red light on the HomeLink
®
transmitter flashes rapidly.
• Release both buttons.
For garage door openers with a “rolling
code,” continue with the following steps:
• Press the training button on the
garage door opener motor head unit,
making sure that the indicator light
flashes to confirm training mode.
• Within 30 seconds, press and hold
the HomeLink
®
transmitter button pro-
grammed in the previous steps.
• Press and release this button up to
three times to ensure that the
HomeLink
®
transmitter has been
trained.
See Section 2 of your Owner Manual.
Rainsense Wipers (if equipped)
These wipers detect moisture on the
windshield and automatically turn the
wipers on.
Activate Rainsense Wipers
• Set the wipers to one of the five delay
settings on the turn signal/multifunc-
tion lever. The rain sensor automati-
cally controls the frequency of the
wipes from OFF to HIGH speed
according to the amount of moisture
on the windshield.
See Section 3 of your Owner Manual.
Note: Turn this feature off before enter-
ing an automatic car wash.
15804 Trailblazer 6/6/03 4:29 PM Page 14
