6.
Figure 8.
7.
8.
Figure 8
5.
Figure7,
Note: Lubrication is not necessary for the ball
joint assembly.
9.
Figure 9
Note: No lubrication is required for the gear
or rack teeth. Oil or grease will gather debris,
making the horizontal adjustment of the power
feeder difficult.
10.
Figure 10
Note: Make sure that you do not tighten the
hex bolts so much as to prevent the arm from
sliding in and out of the arm bracket when the
horizontal crank is turned.
11. Figure 10
Figure 9
Figure 10.
Figure 9.
Figure 7.
Figure 8.
