How to fill rinse aid
Rinse aid
This product makes dishes sparkle and helps them to dry without
spotting. The dispenser is located on the inside panel of the door.
When the low rinse aid indicator “ 1 ” is bright ,it means the rinse
aid is low,you must load rinse aid .
Loading the rinse aid
Regardless of the type of detergent dispenser installed on your
appliance, you must proceed as indicated below when loading the
rinse aid.
To open the dispenser, turn the "2" cap in an anti-clockwise direction
and then pour in the rinse aid, making sure not to overfill. The amount
of rinse aid used for each cycle can be regulated by turning the "3"
dose adjustor, located beneath the "2" cap, with a screwdriver. There
are 6 different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot-
ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white
streaks, turn the dosage adjustor to a lower setting.
2
3
Low
Full
8
1
en
ºdH ºmmol/l
Hardness of the water
Salt
consumption
(Grams/cycle)
Autonomy
(cycles/2kg)
0J10 MJNT
MJNIT
NIUJQIQNUJQQNMJOR
ORJRM QRJUV QIRJUIV
[UV[RM [UIV
L
=?J?
jba
LM
OM
QM
SM?H?
SM
QM
OR
ºfH
Selector
knob
position
It is recommended that adjustments be made in accordance with the following table:
The default setting of the water softening system is -.
- If using multi-functional tablets fill the salt dispenser and set the adjuster to -; if the hardness of the
water is greater than 60ºfH, set it to +.
