A SERVICE OF

logo

Open as PDF
next previous
Removal and replacement procedures 41
4.
Close the processor retaining latch and the processor socket retaining bracket.
5. Clean the old thermal grease from the heatsink and the top of the processor with the alcohol swab.
Allow the alcohol to evaporate before continuing.
6. Apply all the grease to the top of the processor in one of the following patterns to ensure even
distribution.
CAUTION: The heatsink thermal interface media is not reusable and must be replaced if the
heatsink is removed from the processor after it has been installed.
7. Install the heatsink ("Heatsink" on page 31).
IMPORTANT: Install all components with the same configuration that was used on the failed
system board.
8. Install all components removed from the failed system board.
9. Install the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
31).