Hardware options installation 61
6.
Install the PCI-X/PCI Express I/O expansion board.
7. Install any expansion boards ("Installing an expansion board" on page 54).
8. Slide the processor memory drawer back into the server.
9. Install the access panel (on page 27).
10. Slide the server back into the rack.
11. Power up the server (on page 25).
HP NC524SFP Dual Port 10GbE Module option
IMPORTANT: The NC524SFP Dual Port 10GbE Module option is compatible only with the
NC375i SPI board.
When installed on the SPI board, the HP NC524SFP Dual Port 10GbE Module provides two 10G NIC
connectors for server I/O. When the HP NC524SFP module is installed, 1G NIC connectors 1 and 2 on the
rear panel are unavailable.
IMPORTANT: When both an HP NC524SFP module and an optional HP NC522SFP Dual Port
10GbE Server Adapter are installed in the server, only expansion slot 1 has Wake On LAN
capability.
To install the component:
1. Power down the server (on page 25).
2. Disconnect the network cables.
3. Extend the server from the rack (on page 25).
4. Remove the access panel (on page 26).
5. Remove the SPI board (on page 28).
