1-1
Installing the Management Module
Installing the Management
Module
1
Installing the Management Module
The HP J3178A AdvanceStack Switch 208/224 Management Module is installed
into the front of the HP AdvanceStack Switch 208T or 224T.
In this manual, this module will be called the Switch Management Module.
Figure 1-1. The Switch 208/224 Management Module
When installed, the Switch Management Module adds these features to your
switch:
■ Access to the switch console from which you can configure, monitor, and
troubleshoot the switch
■ Access to the switch from SNMP network management programs, such
as HP AdvanceStack Assistant, for controlling the switch using an
advanced, graphics-based interface
■ Configurable full-duplex port operation
■ Configurable support for the Spanning Tree Protocol for switched
networks
■ Configurable MAC Address Table aging
This chapter shows you how to install your Switch Management Module.
Switch Management Module
Base MAC Address
Active
YUMAMOD.BK : 1_yminst.fm5 Page 1 Thursday, February 20, 1997 12:54 PM
