100 HP ProLiant ML310 Generation 3 Server User Guide
7. Power up the server ("Powering up the server" on page 21).
Manual recovery
To manually set the server for ROMPaq disaster recovery:
1. Power down the server ("Powering down the server" on page 21
).
2. Remove the access panel ("Removing the access panel" on page 22
).
3. Set positions 1, 4, 5, and 6 of the system maintenance switch to On.
4. Insert a ROMPaq diskette with the latest system ROM from the SmartStart
CD or the HP website (http://www.hp.com/support
).
5. Install the access panel ("Installing the access panel" on page 23
).
6. Power up the server ("Powering up the server" on page 21
).
7. Allow the system to boot completely.
8. Repeat steps 1 and 2.
9. Set positions 1, 4, 5, and 6 of the system maintenance switch to Off.
10. Repeat steps 5 and 6.
Other information resources
For additional troubleshooting information, refer to the HP ProLiant Servers
Troubleshooting Guide on the Documentation CD.
For information on warranties and service and support upgrades (Care Pack
services), refer to the HP website (http://www.hp.com/support
).
