THE REMOTE CONTROL
NOTES: 1. Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the multi picture display, the
mode will not change to power save mode.
2. Please be careful since image retention will occur if display is left in a multi picture display state for a long period of
time
MULTI PICTURE (PinP)
Activating the 4 pictures mode from the TV screen
Pressing the MULTI MODE button one time at the 2 pictures mode will display 4 pictures.
• Press [A/B] button to select picture A or picture B indicated by a red triangle. For pictures on
right, press ̆̄ SELECT buttons to select picture. The selected channel number would
change green.
• The TV channel can be changed by pressing the ̆ and ̄ PROGRAM UP/DOWN buttons on
the remote control.
• The audio can only be output from picture A in 4 pictures mode.
• The same signal input mode cannot be selected for each screens at the same time.
• Pressing the MULTI PICTURE button at the 4 picture mode will cancel the multi picture mode.
And then, pressing the MULTI PICTURE button again will display the 4 pictures.
• Refer to the table for 4 pictures mode.
Activating the 12 pictures mode from the TV screen
Pressing the MULTI MODE button one time at the 4 pictures mode will display 12 pictures.
• Starting from channel 1, preset channels will automatically display in sequence on the 12
windows.
• This function activates only in TV mode.
• After several seconds, it refreshes the picture one by one.
• Pressing the MULTI PICTURE button at the 12 picture mode will cancel the multi picture mode.
And then, pressing the MULTI PICTURE button again will display the 12 pictures again.
• Pressing the MULTI MODE button at the 12 picture mode will display the 2 pictures
(Split) mode.
