FRONT PANEL CONTROLS
10
FIRST TIME USE
ቦ POWER button
Display Monitor “MAIN POWER” button
This power button is for the complete system, and must be turned ON/OFF manually. It is recommended to leave the “MAIN
POWER” to ON condition (lights red) for stand-by mode.
AVC POWER button
The AVC power can be turned ON/OFF manually or by remote control. Turning on the AVC Power will only turn on the AVC box if
the “MAIN POWER” of the display monitor is off.
ቧ POWER light indicator
To turn the monitor ON, press the main power switch located on the lower right side of the monitor (lower left for 50”). A red stand-
by indicator lamp located on the lower right corner of the front bezel will illuminate (lower left for 50”). The PDP is now ready for
remote on/off operation.
ቨ REMOTE CONTROL sensor
Point your remote at this area when selecting channels, adjusting volume, etc.
ቩ FRONT INPUT JACKS (for VIDEO: 5)
Use these audio/video jacks for a quick hook-up from a camcorder or VCR to instantly view your favorite show or new recording.
press the VID5 button on the remote control button and VIDEO: 5 appears in the top right corner of the TV screen. If you have
mono sound, insert the audio cable into the left audio jack.
ቪ PHONES JACK
Use this jack for your head-phones. The TV’s internal speakers can also be heard. Turn off the internal speakers (see page 48) if
you wish to listen to the head-phones only.
ቫ LEARNING AV NET Sensor
Point your equipment’s remote control at this area while using the AV NET Learning Wizard.
NOTES: 1. Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input when VIDEO: 1, 2,
3, 4, 5, or RGB is selected. Check the Power Light to make sure the Display Monitor is turned off or in Stand-by
mode (lights red) when not in use.
2. Remote Control can not turn ON/OFF the “MAIN POWER” of the display monitor.
OFF.
AVC Center power is ON.
input except antenna (no sync. signal).
