Concept
Concept Manual
1212
29)
30)
31)
32)
Please observe all recomendations on
cooling.
Air is sucked in through vents on front edge of
your mixer,it is then blown out by the fan .
Do Not Obstruct Vents Or Fan Aperture Or
You Risk Thermal Shutdown Of Your Mixer
In the event of thermal failure ,Do not switch
your mixer off as it will automaticaly reset after
few minutes.Switching the mixer off,switches
the fan off thus stopping cooling.
MIXER COOLINGMIXER COOLING
48V Phantom Power is provided for
condenser microphones.
It is globaly switched to all mic XLR sockets
via this recessed switch.
Phantom power must always be switched off
when using unbalanced sources connected to
mic inputs otherwise the source may be
damaged
48V Phantom
Power connection is provided on a 3 pin IEC
mains connector.Never disconnect the ground
from your mixer as this is potentialy lethal..
The mains fuse is a 20mm Time delay fuse.
See rear panel for fuse rating
Switches the amplifier on and off.
MAINS INLETMAINS INLET
MAINS FUSEMAINS FUSE
MAINS SWITCHMAINS SWITCH
SPEAKER OUTPUTSSPEAKER OUTPUTS
Speaker jack connector are provided for the
connection to loudspeakers.
The Concept 8 mixer is able to deliver 2 *
150W into 4 Ohms
The Concept 6 mixer is able to deliver 2 *
100W into 4 Ohms
Under no circumstances should the total load
seen by any of the amplifiers be below 4 ohms
otherwise thermal shutdown is likely and long
term reliability may be impaired.
Rear Panel Facilities
5C
28)
27)
28
30
31
32
29
CONDENSER MICS
FOR
OFF
ON
PHANTOM POWER
4 OHMS
MINIMUM LOAD
DO NOT OBSTRUCT AIR OUTLETDO NOT OBSTRUCT AIR OUTLET
4 OHMS
MINIMUM LOAD
8P-8601
150 WATTS
OUTPUT POWER
CHANNEL
RIGHT
LEFT
CHANNEL
OUTPUT POWER
150 WATTS
OUTPUTS
SPEAKER
I
O
MADE IN THE UNITED KINGDOM BY
BLT Industries Ltd
POWER FUSE RATING
100-120V = T6.5A
I
CAUTION
BEFORE USING THIS APPARATUS
REFER TO USER MANUAL
WARNING
THIS APPARATUS MUST BE EARTHED
MAXIMUM POWER CONSUMPTION
600 WATTS 50/60Hz~
CAUTION
DISCONNECT POWER CORD
BEFORE REMOVING COVERS
WARNING
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK DO NOT
EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE
~
230V = T3.15A
ATTENTION
REMPLACER LE FUSIBLE PAR LE MEME ET LE CALIBRE
ATTENTION
DEBRANCHER A LA PRISE
SECTEUR AVANT D'OUVRIR
AVIS
RISQUE DE CHOC - NE PAS OUVRIR
CAUTION
REFER SERVICING TO
QUALIFIED PERSONNEL
SUPPLY VOLTAGE = 230V
REPLACE ONLY WITH SAME TYPE AND RATING
TO AVOID FIRE HAZARD
CAUTION
300W
Powered
Mixer
300W
Powered
Mixer
Laney
