ENGLISH
|
9
MICROFIBER PADS
1. Lay one Microber Pad on at surface, with two fastener strips facing upward.
2. Align Mop Head with Microber Pad. Make sure Mop Head is oriented with Pad as shown,
and centered as best as possible (See gure 2-A).
3. Press Mop Head rmly down onto Microber Pad. Fastener strips will adhere to Pad Grips on
underside of Mop Head. Pad should now be attached and ready for use (See gure 2-B).
CAUTION: Use care when handling a recently used Microber Pad, as it may still be hot.
NOTE: Microber Pads are machine washable. To avoid picking up lint, washing sepa-
rately from other fabrics is recommended. Only use liquid detergent. Avoid using any
fabric softeners or bleach. Air drying is recommended; machine drying on a low heat
or air dry setting is acceptable as well.
The Mop Head and Microber Pads are perfect for use on these hard oor surfaces:
IMPORTANT: Do not use on unsealed hardwood or unglazed ceramic surfaces. Sur-
faces that are not properly sealed may be warped or damaged by exposure to heat and
moisture.
Care should also be taken when steaming sealed hardwood oors, as prolonged ex-
posure to steam in a single spot may cause damage and discoloration. To avoid this,
keep the Mop Head in constant motion on these surfaces.
Steam may remove the sheen from some oors that have been treated with wax.
Extremely rough textured oors may tear or damage Microber Pads.
Before steaming any ooring, it is recommended to consult the manufacturer’s guide-
lines. For ooring in question, always test on a small inconspicuous area before pro-
ceeding.
•
Sealed Laminate
•
Linoleum
•
Glazed Ceramic
•
Granite
•
Sealed Hardwood
•
Stained Concrete
•
Marble
•
Vinyl
•
Tile
Assembling Your Canister Steam
System
A B
FIGURE 2
