3
PREPARATION FOR USE (CONTINUED)
SPEAKER CONNECTION
1. Place the speakers in convenient locations on either
side of the unit. Usually a distance of five to eight feet
between speakers provides the best stereo effect, but
this may vary depending on the size and acoustics of
the room.
2. Locate the Speaker Terminals on the rear of the unit
and connect the solid black wires to the red (+) terminals
and connect the striped wires to the black (–) terminals.
3. To connect the speakers, press the terminal down, insert
the speaker wire and press the terminal back to the lock
position.
4. Pull lightly on the connection to make sure it is secure.
5. Connect the Speaker Light cable to the Speaker Light
jacks. These will light up the logo on the speakers.
CAUTION: Only connect the speakers which are supplied
with the unit. The use of any other or additional speakers
may cause damage to the unit. Never operate the unit
without the speakers connected.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer’s directions.)
BATTERY OPERATION
The battery compartment is located on the rear of the remote control.
• Remove the battery compartment door by pressing down and sliding the door in
the direction of the arrow.
• Insert two (2) AA size batteries into the battery compartment as shown to the right.
Be sure to observe the polarity markings which are engraved inside the battery
compartment. If the batteries are inserted incorrectly, the remote control will not
operate.
• Replace the battery compartment door.
