Model 2701 Configuration page MIB variables description 152
Model 1001MC Operations Guide 7 • Model 2701RC management
• rdl-csuWithpate(12)
• rdl-remote(13)
Software Test Mode (testModeSet2701RC)
This is used to invoke test modes through the NMS. Available options are:
• off(1)-No test mode in process
• pat(2)—Pattern generator (511) turned on
• pate(3)—HPattern generator with errors (511/E) turned on
• lal(4)—Local loopback test
• lalWithpat(5)—Local loopback test with (511) pattern generator
• lalWithpate(6)—Local loopback test with (511/E) pattern generator with errors
• rdl(7)—Remote loopback test from V54
• rdl-Withpat(8)—Remote loopback test with 511 from V54
• rdl-Withpate(9)—Remote loopback test with errors (511E) from V54
RDL Response(v54Loop)
The following options are available:
• enabled(1)—The unit will respond to a V.54 loop up command
• disabled(0)—The unit will ignore a V.54 loop up command
FP Switches (frntSwitch)
This selects if the front panel toggle switches used for loopbacks and pattern generators are:
• enabled(1)
• disabled(0).
Pattern Select (patternSelect)
The following options are available:
• qrss(0)—QRSS is the pattern that is used when the pattern generator and detector are turned on
• five11(1)—511 is the pattern that is used when the pattern generator and detector are turned on
• two047(2)—2047 is the pattern that is used when the pattern generator and detector are turned on
Loop Timeout (loopTo)
This selects the amount of time that the unit will remain in test mode when the remote test mode is invoked.
If the responding unit is not taken out of test mode within this time period, the unit will automatically time
out and return to normal data mode.