A SERVICE OF

logo

Chapter 12: Command Line Interface (CLI)
265
Name Command
The name command is used to configure the network name. The syntax
of the name is:
name [devicename <devicename>] [hostname <hostname>]
Device name configuration
devicename <devicename> Device Name
hostname <hostname> Preferred host name (DHCP
only)
Name Command Example
The following command sets the network name:
Admin > Config > Network > name devicename My-KSX2
IPv6 Command
Use the IPv6_command to set IPv6 network parameters and retrieve
existing IPv6 parameters.
Ipv6_interface mode enable ipauto none ip
2001:db8:290c:1291::17 prefixlen 128 gw
2001:db8:290c:1291::1