6
3: Install the top wire to the grass bag. Tie the slider to
the top wire. Fold bag opening into a "Z" and install
slider. See Figure 17.
FIGURE 17
4: Install grass bag on the mower as shown in Figure
18.
FIGURE 18
WARNING
DO NOT operate without entire Grass Catcher or
guard in place. Grass Catcher components are
subject to deterioration during normal use. Inspect
frequently and replace worn or damaged
components immediately.
FOAM BLADE BLOCK REMOVAL
Tip mower back against the upper handle to gain access to
the underside of the cutting blade. Remove foam shipping
block from cutting blade. This must be removed before
starting the engine.
IMPORTANT: DO NOT tip machine with carburetor or
spark plug down. Oil from crankcase will saturate the air
filter and cause the engine to be hard to start or not start
at all. If contamination does occur, the air filter will have
to be replaced.
Assembly is complete. Complete all items on the
Pre-Operation Checklist as instructed.
BAG
SLIDER
“Z” FOLD BAG
AS SHOWN
SLIDE CONNECTOR
OVER END OF
ADAPTER FLANGE
HOOK BAG HANDLE
OVER MIDDLE HANDLE
