© Titan Tool Inc. All rights reserved. 3
General Repair & Service Notes
WARNING: Before proceeding, follow the Pressure
Relief Procedure outlined in the “Warning” section of
this manual. Additionally, follow all other warnings to
reduce the risk of an injection injury, injury from mov-
ing parts, or electric shock. Always unplug the sprayer
before servicing!
The following tools are needed when repairing this sprayer:
Phillips Screwdriver 3/8"Allen Wrench
Needle Nose Pliers 5/16" Allen Wrench
Adjustable Wrench 1/4" Allen Wrench
Rubber Mallet 3/16" Allen Wrench
Flat-blade Screwdriver 1/8" Allen Wrench
1/2" Open End Wrench
1. Before repairing any part of the sprayer, read the
instructions carefully, including all warnings.
2. When disconnecting wires, use needle nose pliers to
separate mating connectors.
CAUTION: Never pull on a wire to disconnect it. Pulling
on a wire could loosen the connector from the wire.
3. Test your repair before regular operation of the sprayer
to be sure that the problem is corrected. If the sprayer
does not operate properly, review the repair procedure
to determine if everything was done correctly. Refer to
the Troubleshooting Charts to help identify other
possible problems.
4. Make certain that the service area is well ventilated in
case solvents are used during cleaning. Always wear
protective eyewear while servicing. Additional
protective equipment may be required depending on
the type of cleaning solvent. Always contact the
supplier of solvents for recommendations.
5. If you have any further questions concerning your
TITAN Airless Sprayer, call TITAN:
Customer Service Department..............1-800-526-5362
Fax ........................................................1-800-528-4826
Outside the U.S. Call.............................1-201-405-7520
Outside the U.S. Fax ............................1-201-405-7449
Canada .................................................1-800-565-8665
Fax........................................................ 1-905-856-8496
Electrical
Box
Return
Hose
Bypass
Valve
Outlet
Fitting
Motor
Pressure
Control Knob
Siphon Down
Tube
Paint
Filter
Add piston
seal lubricant
(P.S.L.) here
Fluid Section
Pail Hook
