31
Key Accessories and Service Kits
These items may be purchased separately from
your local TITAN/SPEEFLO distributor.
PART NO. DESCRIPTION
103-826 Syphon Hose Assembly with Rock Catcher 1" x
4-1/2"'
103-827 Syphon Hose Assembly with Rock Catcher
1" x 6-1/2'
103-627 Rock Catcher
930-005 Paint Filter Element, 5 Mesh (for multicolors
and heavy materials)
930-006 Paint Filter Element, 50 Mesh (for latex and
normal architectural materials)
930-007 Paint Filter Elements, 100 Mesh (for stains,
lacquers and fine materials)
711-001 Gun and Hose Kit - For Architectural Coatings -
(includes 520-100 Gun with 641-517 SC-5
Reversible Tip and 250-514 1/4" x 50' 3000 psi
Airless Hose Assembly)
711-003 Gun and Hose Kit - For Heavy Materials -
(includes 801-309 Heavy Material H-Gun
w/Swivel, 250-138 3/8" x 50' 3500 psi Airless
Hose Assembly, 641-300 SC-5 Safety Guard
and 641-621 SC-5 Reversible Tip, .021 x 60
O
)
160-124 Nylon Paint Strainer - 1 Gallon (Pack of 24)
160-524 Nylon Paint Strainer - 5 Gallon (Pack of 24)
101-208 Grounding Clamp
101-212 Grounding Wire, 12 Gauge x 25'
700-925 Piston Lube
430-362 Coolflo™ Hydraulic Fluid, 1 Quart
430-361 Coolflo™ Hydraulic Fluid, 1 Gallon
143-050 Service Kit for PowrTwin 4500™ Fluid Pump
930-050 Service Kit for Paint Filter
944-050 Service Kit for Bleed Valve
975-212 2-Gun Manifold with Ball Valves, 1/4"
975-213 3-Gun Manifold with Ball Valves, 1/4"
975-312 2-Gun Manifold with Ball Valves, 3/8"
975-313 3-Gun Manifold with Ball Valves, 3/8"
(1) Pull washer and O-Ring
back as far as possible.
(2) Lubricate O-Ring and
entrance port.
(3) Screw fitting in until wash-
er pushes O-Ring into
entrance and sits flat against
port.
(Do not tighten! - only do this
step hand tight to compress
O-Ring into port!)
(4) Back fitting out no more
than one complete turn to
align as required.
(5) Torque nut wrench tight
holding backup on fitting. This
should expose a recess gap
behind the nut which can act
as a tattle tale that the fitting
is assembled correctly.
NOTE: This is a feature for a
specific version of this fitting
only - which screws into the
cylinder head. Other fittings,
as the ones which attach to
the hydraulic pump, assemble
the same but may not have
the tattle tale.
SAE O-RING FITTING INSTALLATION
1 & 2
3
4
5
Avoid Screwing Fitting in too far!
