© Titan Tool Inc. All rights reserved. 13
Pole Guns Operation
Independent controls are provided for air and uid. Those
controls will give positive shut-off or may be used for throttling
ow for full control of spray. Accordingly, a small amount of uid
and air permit spot application and control at roof edges and
around masked areas. Fully opened valves allow maximum
production on open areas.
NOTE: Air valve (11) must be opened or closed to
activate the StediFlo™ valve. If material valve
(13) is closed and the air valve is left open, the
pump will not stop until pressure builds. The
resultant surge when the material valve is opened
will give a momentary quantity of excessive
material.
Maintenance
A faulty spray may be caused by dried material around the uid
nozzle or the air cap. Soak in thinners to soften and remove with
brush or cloth. Never use metal objects to clean the air cap or
uid nozzle. Should either become damaged or worn, they must
be replaced to obtain a perfect spray.
Intermittent spray may be caused by dirt between the uid nozzle
seat and the gun head, or a loose nozzle. To correct, remove
the uid nozzle and clean seating surfaces with thinners and ret
nozzle tightly.
Specications
Type of work
Nominal air
consumption
cfm 1/m psi atm
Air
pressure
Air cap
Part No.
Fluid nozzle Spray
Mastics, Textures,
Fibrated Coatings
Fireproofing, Ingulation
5-15 142-426
5-15 142-426
40-80 3 - 5.5
40-80 3 - 5.5
701-620
701-616
701-626 3/16”- 4.75mm
701-626 3/16”- 4.75mm
Round
Flat
As above but capable
of higher speed of
application
10-20 284-528
10-20 284-528
40-80 3 - 5.5
40-80 3 - 5.5
701-621
701-617
701-624 1/4”- 6.3mm
701-624 1/4”- 6.3mm
Round
Flat
As above but capable
of higher speed of
application
15-25 426-710
15-25 426-710
40-80 3 - 5.5
40-80 3 - 5.5
701-622
701-619
701-628 3/8”- 9.5mm
701-628 3/8”- 9.5mm
Round
Flat
