Curved Line Striping
The side striper can be
configured to paint a curved
line.
1. Mount the gun pole
support on the front axle.
2. Loosen the support
knobs for the gun pole
support.
3. Rotate the rear wheel up
so that only the front two
wheels touch the ground.
The side axle and rear
wheel should be standing
vertical above the front
axle and front wheels.
4. Tighten the two support knobs for the gun pole support
securely.
5. Loosen the gun pole knob to adjust the angle and height
of the gun for the desired stripe size. Tighten the gun
pole knob securely.
Painting a Curb
The side striper can be
configured to paint a curb
1. Mount the gun pole
support on the side axle
evenly spaced between
the two wheels. Make
sure the spray gun is
pointing to the outside of
the axle assembly.
2. Loosen the gun pole
knob to adjust the angle
and height of the gun.
Point the gun at the bend
of the curb so paint is evenly sprayed on both the
horizontal and vertical parts of the curb. Tighten the gun
pole knob.
NOTE: It is important to tighten the gun pole knob
securely when configuring the side striper to
paint a curved line. If the knob is not tight
enough, the side axle and rear wheel will slip
down to ground level.
Cleanup
Special cleanup instructions for use with flammable
solvents:
•Always flush spray gun preferably outside and at least one
hose length from spray pump.
• If collecting flushed solvents in a one gallon metal
container, place it into an empty five gallon container, then
flush solvents.
• Area must be free of flammable vapors.
• Follow all cleanup instructions.
The sprayer, hose, and gun should be cleaned thoroughly
after daily use. Failure to do so permits material to build
up, seriously affecting the performance of the unit.
Always spray at minimum pressure with the gun nozzle tip
removed when using mineral spirits or any other solvent
to clean the sprayer, hose, or gun. Static electricity
buildup may result in a fire or explosion in the presence of
flammable vapors.
1. Follow the “Pressure Relief Procedure” outlined in the
airless sprayer’s owner’s manual.
2. Follow the “Cleanup” procedure outlined in the airless
sprayer’s and spray gun’s owner’s manuals.
3. Wipe down all surfaces of the side striper.
4. Store the side striper in a clean, dry area.
