3©Titan Tool Inc. All rights reserved.
General Repair and Service
Notes:
The following tools are needed when repairing this
sprayer:
Phillips Screwdriver
Needle Nose Pliers
Adjustable Wrench
Rubber Mallet
Flat-blade Screwdriver
5/32" Allen Wrench
1/4" Allen Wrench
1. Before repairing any part of the sprayer, read the
instructions carefully, including all warnings.
2. When disconnecting wires, use needle nose pliers
to separate mating connectors.
CAUTION: Never pull on a wire to disconnect it.
Pulling on a wire could loosen the connector from the
wire.
3. Test your repair before regular operation of the
sprayer to be sure that the problem is corrected. If
the sprayer does not operate properly, review the
repair procedure to determine if everything was done
correctly. Refer to the Troubleshooting Charts to help
identify other possible problems.
4. Make certain that the service area is well ventilated
in case solvents are used during cleaning. Always
wear protective eyewear while servicing. Additional
protective equipment may be required depending on
the type of cleaning solvent. Always contact the
supplier of solvents for recommendations.
5. If you have any further questions concerning your
TITAN Sprayer, call the TITAN:
Customer Service Department 1-800-526-5362.
Fax 1-800-528-4826
Outside the U.S. Call 1-201-337-1240
Outside the U.S. Fax 1-201-405-7449
Canada 1-800-565-8665 Fax 1-905-856-8496
ProFinish TS / TSP
CARRYING HANDLE
AND HOSE WRAP
FLIP TOP LID
FORM FITTING HANDLE
FLUID ADJUSTMENT KNOB
AIR ADJUSTMENT KNOB
CAST ALUMINUM BASE
TURBINE
AIR HOSE FITTING
AIR HOSE FROM
TURBINE
FLUID HOSE
FROM
PRESSURE POT
MAY CONNECT
HERE
