Saving Energy
Saving energy is important and helps you save money. This section gives you tips on the
best ways to save energy with your dishwasher.
Loading tips
l Wash full loads. Running a half-filled
dishwasher uses the same amount of
electricity and hot water as a fully loaded
machine.
l Load correctly for best washing results.
Incorrect loading may cause poor washing.
You will then need to rewash all or part
of a load.
l Do not prerinse normally soiled dishes.
Select the correct cycle for the load and
use the recommended amount of
detergent.
Cycle and option tips
l Use the Low Energy/China cycle whenever
possible. The cycle uses less hot water
and energy than the Normal Cycle.
l Use 4 Hour Delay Start to run your dish-
washer during off-peak hours. Local
utilities recommend avoiding heavy usage
of energy at certain times of day.
l Do not use the High Temp Wash option
if it is not needed. When this option is off,
if water entering the dishwasher is lower
than 140°F (6073, the cycle does not take
additional time to heat water during the
main wash.
NOTE: Loads may not wash or dry as well
if the water temperature is too low. For
best dishwashing results, water must be
at least 120°F (49°C) as it enters the
dishwasher.
l Use the Air Dry option whenever possible.
Allow longer drying times (overnight). Use
a rinse agent to improve drying.
To check water temperature:
1. Run hot water at the faucet closest to
your dishwasher. Let the water
run for at least 1 minute.
2. Hold a candy or meat thermometer in
the running stream of water. It
water temperature at the faucet
is below 120°F (49”C), have a
qualified person raise the water
heater’s thermostat setting.
23
