10
4. Connect remaining wires
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover
into slot of dryer rear panel. Secure cover with hold-down
screw. Now, go to “Venting Requirements”.
3-WIRE POWER SUPPLY CORD
CONNECTION
3-wire receptacle (NEMA
type 14-30R)
3-prong plug
Spade terminals with
upturned ends
Ring terminals
Use where local codes permit connecting
cabinet-ground conductor to neutral wire.
1. Remove center screw
Remove center terminal block screw (B).
3. Connect remaining wires
2. Connect neutral wire
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover
into slot of dryer rear panel. Secure cover with hold-down
screw. Now, go to “Venting Requirements”.
Connect neutral wire (white or center) (C) of power supply cord
to center terminal block screw (B). Tighten screw.
Direct Wire
