Filter
Top Products
Operations
Turn the system on and off
Use the power switch to turn the SelfCheck system on. For information on shutting the system down and on restarting the software,
see the SelfCheck Manager User Guide, which is included on the user documentation CD.
Load printer paper
Use the following procedure to load a new roll of paper in the
printer.
1. Open the printer access cover at the rear of the SelfCheck
using the key. The 3M
™
Dual Lock
™
anchors will secure
the cover open.
2. Swing the paper retainer toggle to the unlocked position
and, if present, remove the used paper spool and any paper
remnants in the printer.
3. With the paper roll positioned to unroll toward the printer
as shown, slide the new paper roll over the toggle and onto
the spool, then swing the toggle into the locked position
as shown.
4. With printer power on, feed the paper end into the slot near
the top of the printer. The printer will automatically load,
align, and cut the paper.
Open cover to access printer and paper roll spindle
Toggle operation: locking and unlocking
Note the slot shape and orientation in the locked and unlocked
positions. The toggle must be snug against the paper roll (no
gap) in the locked position for proper printer operation.
© 3M 2011. All rights reserved.
9