American Dynamics ADSDUHOC Security Camera User Manual


 
SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C
INSTALLATION GUIDE - CONTINUATION
7 of 12
Housing Termination and
Video Configuration
Both the outdoor housing and dome
camera are shipped “terminated” for when
they are installed at the end of a data
cable. Should the cable continue to
another dome, “unterminate” the housing
using the following procedure.
IMPORTANT! Leave the dome camera set
to “terminated.”
Unterminating the Outdoor Housing
CAUTION: The environmental circuit
board inside the housing is static
sensitive! Touch the metal housing to
discharge it before touching the board.
1. As shown above, detach the circuit board from
the housing by:
A. Pushing fingers molded into the base away
from the board while
B. Pulling on the dust cover protecting the
board’s spring finger connector.
Note: Keep the dust cover in place for the
next two steps.
On the circuit board:
2. Set the termination jumper E1 according to the
dome’s position in the communications line.
Position of dome in
communications line… Setting Pins
Between other devices Unterminated Off
End of communications line Terminated 1-2
Note: You may need a small slotted screwdriver
to gently pry the jumper loose. Be careful not to
damage the PC board.
3. Connect video and set jumpers:
Coax: Connect to the I/O board BNC video
cable extension and leave video
configuration jumpers E2 and E3 across pins
1 and 2 (default position). These pins are
closest to the video extension cable.
UTP: Connect to plug P5 and place video
configuration jumpers E2 and E3 across pins
2 and 3 (pins farthest to the video extension
cable).
TB5 Pin Designations
Pin Designation
1 Video Hi
2 Video Lo
A
B
Video
UTP
Video
Extension
Cable BNC
Termination
Jumper
Video
Config.
Jumpers
E2, E3
(Default
= Pins 1
and 2)