Filter
Top Products
SPEEDDOME ULTRA VII CAMERA DOME CONFIGURATION UTILITY 8200-0184-09, REV. A
OPERATOR’S MANUAL SUPPLEMENT
9 of 13
MegaPower LT
Supported Protocol SensorNet
Maximum Presets 96
Maximum Patterns (1) 3
Quick Set Menu Yes (2)
Address Range 1-32
Notes:
(1) Patterns are limited by time and the number of
available dome commands. Total time for each
pattern cannot exceed 6 minutes 50 seconds. Total
dome commands used in all patterns cannot exceed
99.
(2) Requires a compatible keyboard.
MegaPower 48
Supported Protocol SensorNet
RS-422
Maximum Presets 96(1)
Maximum Patterns (2) 3
Quick Set Menu Yes (3)
Address Range 1-48
Notes:
(1) Preset information is stored at the host, not the
dome.
(2) Patterns are limited by time and the number of
available dome commands. Total time for each
pattern cannot exceed 6 minutes 50 seconds. Total
dome commands used in all patterns cannot exceed
99.
(3) Requires firmware 1.07 or newer and a compatible
keyboard.
MegaPower 1024
Supported Protocol RS-422 (1)
Maximum Presets 16 (2) or 60 (3)
Maximum Patterns (4) 3
Quick Set Menu Not supported
Address Range 1-1024 (5)
Notes:
(1) Requires the AD2083-02 series code converter.
(2) Preset information is stored at the converter, not the
dome.
(3) Requires AD2083-02 with firmware version 0701-
11YB-156A or newer. Preset information is stored in
the dome, not the converter.
(4) Patterns are limited by time and the number of
available dome commands. Total time for each
pattern cannot exceed 6 minutes 50 seconds. Total
dome commands used in all patterns cannot exceed
99.
(5) Requires additional equipment to achieve these
numbers. A dome address within each group of 64
or 99 cameras is reserved as a global broadcast
address.
Panasonic UTC Protocol
Preset Programming
The Dome Configuration Menu must be used to
program Presets. Up to 64 Presets may be
programmed using the Panasonic UTC protocol.
These instruction apply to the following equipment:
• Panasonic WJ-SX550 Multiplexer
• Panasonic WV-CU550A Controller
1. Select the monitor and camera number
assigned to the Speed Dome Ultra VII camera
dome.
2. Use the arrow keys on the controller to scroll to
the Camera Setup Menu (D4).
3. Press F1 (On) key to display the Dome
Configuration Menu.
4. Use the joystick to move the highlight to
Alarms/Areas/Home/Presets/PZ. Press Set
to select.
ALARMS/AREAS/HOME/PRESETS/PZ
SET ALARM ACTIONS
SET ALARM STATES
SET HOME POSITION
SET NORTH POSITION
AREA BOUNDARIES
PRIVACY ZONES
PRESETS
SCAN LIMITS
EXIT