Filter
Top Products
SPEEDDOME ULTRA VII CAMERA DOME CONFIGURATION UTILITY 8200-0184-09, REV. A
OPERATOR’S MANUAL SUPPLEMENT
3 of 13
Command Description
14+Quick Set* WDR Off: Disables Wide
Dynamic Range (WDR). Use this
setting when the light level is
constant or changes in lighting
conditions are gradual.
15+Quick Set Smooth Scan: Initiates a smooth
scan between the left and right
scan limits, starting at the left
scan limit. If no scan limits have
been set, initiates a smooth 360°
clockwise rotation around the
dome axis using the current tilt,
zoom and focus settings.
16+Quick Set Stepped Scan: Initiates a scan
between the left and right scan
limits pausing briefly every 10° (at
1x zoom), starting at the left scan
limit. When the right scan limit is
reached, the scan is reversed. If
no scan limits have been set,
initiates a clockwise rotation
around the dome axis pausing
briefly every 10° (at 1x zoom) for
3 seconds using the current tilt,
zoom and focus settings.
17+Quick Set Random Scan: Initiates a scan
between the left and right scan
limits pausing randomly between
the limits. If no scan limits have
been set, initiates a clockwise or
counter-clockwise rotation around
the dome axis using the current
tilt, zoom and focus settings. The
dome pauses randomly as it
rotates around the axis.
20+Quick Set Dome Information: Displays the
Dome Information screen
available through the dome
configuration menu.
Refer to your controller manual to determine if the
Quick Set Menu feature is supported. For more
information about these settings, see your
SpeedDome Ultra VII Configuration Utility
Operator’s Manual. See also:
Topic Page
Auto Iris/Auto Focus Resume Setting 3
Scan Limits 4
AD Up-the-Coax Protocol 5
SensorNet and RS-422 Matrix
Switchers and Controllers
6
Auto Iris/Auto Focus
Resume Setting
Normally, the camera’s iris and focus settings
return to automatic mode when the dome moves a
minimum of one frame from its current pointing
position. In some situations, you may want to
maintain specific iris and/or focus adjustments
based upon your surveillance needs.
Use the I/F Return to Auto setting on the
Pan/Tilt/Zoom/Sync Opts menu to configure the
auto iris and auto focus resume settings.
Figure 3: Pan/Tilt/Zoom/Sync Options menu
PROPORTIONAL FLIP OFF/ON
1ST ZOOM STOP X 33/22
MAX TOTAL ZOOM X 44...242
LINE LOCK ON/OFF
FREEZE FRAME OFF/ON
I/F RETURN TO AUTO OFF/ON/
IRIS/FOCUS
Four settings are available: On, Off, Iris and Focus.
Setting Description
On Both return to auto iris and return to
auto focus settings are enabled.
Moving the dome resumes auto mode
for both iris and focus changes.
Off Both return to auto iris and return to
auto focus settings are disabled.
Moving the dome does not resume
auto mode for iris and focus changes.
Iris
Only return to auto iris is enabled.
Return to auto focus is disabled.
Moving the dome resumes auto iris
mode without changing focus settings.
Focus
Only return to auto focus is
enabled. Return to auto iris is
disabled. Moving the dome resumes
auto focus mode without changing iris
settings.
Continue with Changing the Auto Iris/Auto Focus
Resume Setting on page 4 to configure the setting.